Ok, here’s my own secret sauce, all the commands I use to setup a node in about 10-20 minutes. All the domain stuff i’ll leave out here, but just remember that you a domain to put your json (or subdomains for node 2+) and a-records pointing at your VPS IP’s. All commands are separate command’s […]

Continue Reading

There have been quite a few people asking about node metrics to figure out which node they should signal. Until the team has time to set up their own metrics overview i’ve tried to fill the gap with an ethstat server: http://strongstats.mortysnode.nl/ To get your node listed you need to either include an extra setting […]

Continue Reading

Ok, you’ve followed GrzzDad’s guide, setup GETH as a service following my previous post and now… Now you should secure your node a bit more with setting up a reverse proxy for your endpoint access. If you’re running your STRONG node on a Pi4 i’m not sure if this won’t overload the capacity of your […]

Continue Reading

Over the last few days i’ve been helping quite a few people with setting up their STRONG nodes. I’m not going to write up a new complete guide setting up a GETH node and adding the stuff you need for a STRONG node application, Grzzdad has done a great job at that: https://medium.com/@grzzdad/how-to-make-an-ethereum-node-eligible-for-strong-5cac75ace6da I did […]

Continue Reading